Delton PC-80D Manuel d'utilisateur Page 12

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 39
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 11
User Manual for PC-80D Easy ECG Monitor
7
Operation: Connecting the lead wires after placing the electrodes well and then insert the connector onto the device; Power on the device to select
the “limb lead” for signal input and set the measuring time on option setup menu, then press ”ok key to start the measurement.
Note: keep at ease when seating or lying down. Clean the skin by using the wet cloth when selecting limb clip type electrodes (optional) to measure.
Direction of using disposable ECG electrodes: Tearing off the protective film to place it on the skin, and then connecting the electrodes with lead
wires. It is recommended to put the electrodes on chest for longtime monitoring, please refer appendix 1 for more details.
2). Electrodes placement for Chest Lead Measurement
On default menu screen enter “ ” option setup menu to select “chest leadfor signal input. ECG signal detected by this method is single channel
measurement, which is equivalent to the waveform of regular chest lead. It is intended for professional use (ie. by doctor). The location of the
electrodes is shown in figure 4-6.
R (red): place on interior of right arm (between the wrist and the elbow);
L (yellow): place on interior of the left arm (between the wrist and the elbow);
F (green): on the 5th intercostal space at the left anterior axillary line;
N (black): unused.
Operation: Connecting the lead wires after placing the electrodes well and then insert the connector onto the device; Power
on the device to select the “chest lead “for signal input and to set the measuring time on option
setup menu, then press ”ok key to start the measurement.
Note:
1. The Chest Lead Measurement can obtain the ECG signal of Chest Lead (V1-V6). Please refer to appendix I to select the location of F (green)
electrode when you want to get the different chest lead. At the same time, you should set the lead information (V1-V6) that you want on the option
setup menu.
2. Either adhesive electrode or sucking bulb electrode (optional) can be used to Chest Lead Measurement. Please refer to appendix I for more details
about measuring methods.
Figure 4-6 the location of chest lead measurement
Vue de la page 11
1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 38 39

Commentaires sur ces manuels

Pas de commentaire